The canopy cannot take the place of the waterproofing beneath the terrace surface.

Above a heated room, the thermal envelope matters too. Connect the terrace insulation to the wall insulation without unnecessary gaps. The canopy, in turn, must carry its own weight and withstand snow and wind. Design its supports and its connection to the building for those loads. Fixing it to the render or wall insulation alone will not do that.

T18 trapezoidal steel sheet gives a small canopy a simple, regular profile. T35 has deeper ribs; check whether it suits the available supports and the design loads. Tile-effect steel roofing can pick up the pattern of the main roof. When comparing finishes, consider what you will see from your seat beneath the canopy as well as from the garden.

Each covering has its own minimum pitch and joint details. Limited height at the door may rule some options out. Keep within the pitch limits specified for the product. Plan the gutter, wall flashing and discharge point together so water stays clear of the access path and building corner. On an exposed terrace, wind can also act on the underside: lightweight sheets need just as much care in the design of their fixings as a heavier covering.

An opaque metal roof shades the terrace and may reduce daylight in adjoining rooms. The effect depends on canopy depth, orientation and window position. Check these together on a plan and section before ordering. The underside colour and any soffit lining also affect how light or enclosed the seating area feels.

Condensation can form on cold sheet metal. Anti-condensation fleece can hold droplets temporarily, but it must be able to dry out. Reducing the sound of rain is a separate task: performance depends on the whole roof build-up, not simply on the presence of fleece. If the terrace is close to a bedroom, consider both issues before choosing the covering.

PIR has low thermal conductivity, which can help where there is little depth for insulation at a threshold or façade junction. That does not make every PIR board suitable for every terrace. First establish the order of the layers, the moisture exposure and how the surface will transfer loads to the insulation.

In a conventional warm roof the insulation sits below the waterproofing. An inverted roof places it above the waterproofing, where exposure is different. Use a material intended for that position, often a suitable grade of XPS. A lower thermal conductivity alone is no reason to substitute a standard PIR board.

Bonded tiles, paving slabs on pedestals and decking transfer loads differently. Pressure under a single pedestal foot can far exceed the average across the terrace. The design should spread these loads and protect the waterproofing. The stiffness of an insulation board alone does not establish that a particular support arrangement is suitable.

Compressive stress at ten per cent deformation is not the permissible permanent load. Long-term deformation and service conditions matter as well. Include planters, heavy furniture and other fittings in the load assessment. A terrace that looks solid may still be unsuitable for an extra concentrated load.

Pay particular attention to the door threshold, wall junctions, edges and balustrade fixings. Detail the waterproofing terminations and drain water from the level specified for the system, including beneath the surface where required. Sealing the tile joints alone cannot replace the waterproofing layer. A low threshold often needs a separate drainage detail coordinated with the door frame.

Coordinate the canopy, balustrades and outlets before laying insulation and waterproofing. That avoids drilling unplanned holes through the finished surface. Keep outlets accessible for inspection and cleaning. A well-designed terrace provides usable outdoor space while protecting the room below; that depends on a coordinated roof design as much as on the visible finish.